ANOTHER ALTERNATIVE ENERGY INVENTOR -Stefan Nystrom- KILLED? Ben FulFord 2008



by Benjamin Fulford
September-03-2008

from Rense Website

A man by the name of Stefan Nystrom invented a way to generate energy from ocean waves that he claims would cost 5% of what coal energy does.

He set up a proto-type in Ghana and, initially, claims to have found many potential investors. However, suddenly problems started to pop up. The investors, originally extremely enthusiastic, started to back off. He was offered bribes in order to quit. Finally, he began to be harassed by Ghanaian police and mercenaries.

He contacted me in hopes of getting protection. I told him to come to Japan. He told me he was not allowed to leave the country. He said they had taken parts from his prototype. I said I would see what I could do.

 Before I could do anything, yesterday I received a disturbing set of phone calls from a very scared sounding Mr. Nystrom.

"They tried to kill me three times today," he screamed into the phone.

Then I lost contact with him, and his phone has been switched off.

In his last call, he asked me to make his technology public. So, here below is a description of his technology.

 Would people please pass it on and would as many people, in a tribute to a man who has probably been killed by mercenaries hired by the oil industry, and make sure that prototypes are developed.

----------------------------------------------------------------------------------------------------------------

Wavereaper™ the Technology
from WavePartner Website

 Waves work in a constant movement up and down, forth and back, and we can with the WaveReaper™, a simple mechanical device take advantage of this in a cheap way.

As we said, the wave move up and down, but most generators, rotate around an axle, and the wave size varies a lot, and creates problems, when you want to utilize the energy content of them. The current technologies regarding wave energy today, is very costly, which brings that can’t compete with other ways of making energy.

Another factor, water, and generators, yes almost any technology, is having problem, when it comes to the oceans salt water without more expensive design and material. Water can leak inside equipment and ruin electrical circuits, and must therefore be safeguarded against corrosion, and in those cases it is under water, against leakage, and pressure. Also water-depth, and the special environment, which crave divers, and other expensive equipment, has made wave energy costly.

With other words, underwater technology is not cheap, with these problems to solve, which means high costs, and therefore more expensive energy for the consumer. This is not what we would like, so it’s needed to solve the wave generation concept, to go around these problems. And the solution is simple, we can use basic items, as wire, plastic barrels, one way bearings, pulley, an axle, flywheel and generator.

That is the main components, in what up to day, is the cheapest wave energy technology in the world. It can even be built in wood or by choice bicycle parts! This is very good, in countries which have limited access to expensive metals, and heavy machining tools.

Most of the parts in a generator, except wiring, can be made of wood or plastics.
 

WaveReaper plastic barrels in the ocean waves

WaveReapers plastic barrels in the waves.
 

We will use a set of plastic barrels as boys, cost is low, and Pvc isn't affected by salty ocean water. The barrels are placed near shore or longer out in deeper water, depending on amount of energy needed in particular wave plant.

Each barrel has a lifting force of approx 100 Kg. A wire is connected to the barrel, which goes to a brass block on the bottom, which is weighted down, with a big stone, and connected to another wire.

The location of choice is the main parameter for the size of the barrels, smaller waves, smaller barrels, and vice verse. Wave heights can possible catch range from 2 foot and up.
 
 

WaveReaper power transmitting wires and blocks transferring force to onshore generator

The number of barrels, can be larger, but i think, for practical reasons, a number of 100 on each plant, would be good, and reasonable, this amount, can in the shore line version, give up to 500 kW of energy, or even more if special locations, and in a plant that covers 100 meter of shoreline, that makes it, 3 mw per kilometer shoreline.

The barrels is on 2 meters distance from each other, and connected to the on mainland placed WaveReaper generator, via the “power transmitting wire” it is also is connected with a thinner wire, between them, so, if the power wire should break, the barrels, don’t get to drift away, in the sea. This will also even out the possibility that the barrels, would smash into each other, when the sea is rougher.

The lifting capacity is also setting a maximum power input into the device, since if it is to large/fast waves, the barrels would not lift more than it can, and forces is kept within the range, chosen when constructing the WaveReaper plant.

Power in kw per meter WaveReaper after losses, est. 30% of figures shown is electricity


Power out put of waves kW per meter of WaveReaper, approx 30% energy after conversion. 

Example, number of barrels in each row 10, and rows 10, the plant would be 20 x 20 meters of area, 400m2, and will have 100 connected wires, which transfer the mechanical energy, to the generator.

This type of plants, give 100 to 300 kW every hour, which generates profits, of 6500 to 20 000 dollars of revenue monthly, building cost of the plant is estimated to 20 000 dollars only.

This give that the WaveReaper earns itself, in a few months, instead of years.


 
WaveReaper set of block which can be hauled in without divers, reverse half-pipes, on stainless steel wire

I have chosen to use cheap materials only, in this demonstration, because the need to bring down production costs, and make it possible to build this type of wave generation device, any where in the world, and with local materials, as car parts etc, which doesn't needs to be imported.

Other materials could of course be used, and the schematics for its design of course, be different. Simple is better, it is said, and fewer parts, and bearings, will bring lower cost of building, and also repair.

We can here see energy content in waves, The numbers means kW per hour, and meters of wave. South America, 97 kW per meter of wave, for example, that means, a Wavereaper™ device, which is 100 meters broad, would generate 9.7 mw, cost would be around 1200 000 Dollar, for that device. However, the revenue would be over 400 000 dollars monthly with current energy price.

This is a simple schematic, showing buoys, wire and one-way bearing, connected together.

In case of storm and rough waves, it is a problem, for all wave energy constructions, however, the Wavereaper™, has a built in safety feature in its construction, that would avoid damage on the equipment, its due to the max lifting force of the barrels, since the will sink under the surface, if the force is to great. this will make the Wavereaper™ possible to work in any weather, however it should be constructed, to take advantage, of the medium wave, that is present at all time, for best cost benefit of the plant.

15 to 300 Kw WaveReaper prototype schematic

The wire is connected to a chain in the end, witch works on a gearwheel sitting on a one-way bearing, mounted on an axle.

This translates the pulling force of the wire, to an circular movement which is good for cheap generators. The wire is for this case 4 mm stainless steel, which give a lifting ability of approx 300 Kg before it brakes.

Also plastic can be used as Pvc band, which today is commonly used for packaging goods on pallets, this type of Pvc band has high strength, and is also light, and cost-effective, of course the UV light from the sun is affecting it in the long run, but the part that is in the water, should be somewhat guarded from the UV rays.

Flywheels is also mounted on the axle, to collect, even out/store the momentum which is produced by the lifting barrel, this will even out and, smooth the turning's of the axle, to the generator, which is driven by a pulley, who will give it correct rpm. A simple brake, which can never wear down, is also planned, in those cases, constant current generators, or a special electronical device is not used.

Pipes mounted on the wire, which means we can haul in and out the device, without leaving the shoreline. With this configuration, if one set of barrels malfunction, only 10% of the plants output is lost, it can be hauled in to the shore and serviced, with ease, and without complicated offshore operations.

When the wire coming to the generator housing, a chain is mounted to the wire, which drive the Gear wheel, and the one way bearing, which makes the chain draw, when the waves raises the barrel, but let it spin freely back, when the wave height is going down again, also a small weight is connected to the chain, to make it even out slack of the wire. A flywheel is mounted, and a pulley drives the generator, evenly.

One-way bearing, with pulley and wire, with bigger loads, chain and gearwheel, is an option. One-way bearings can be seen in ex. bicycles, the rotate freely in one direction, but in the other direction, they grip, and transfer force, this is used in the Wave reaper, and makes it simple, and cost effective.

The waves up and down, movement is translated to rotating movement, suited for a generator, of choice. 


Benefits of the One-way bearing
The barrels will of course jump up and down in random patterns; this will add to an even movement of the generator axle, and its flywheel, as soon as a wave has energy to contribute, it will transmit its force to the wire, and to the axle.

The flywheel is storing the momentum gained from the waves temporarily.

Because of its design, the WaveReaper, is always self adjusting regarding wave height, and tidal shifts, and higher or lower water levels due to shifting weather patterns, no adjustment needed, the Wavereaper™ is always balancing itself out, to optimal level in the ocean.
 

WaveReaper Onshore version in the ocean
No computer monitoring is needed and that also brings costs down, and no complicated technology, which would need delicate conditions, or a lot of service.

This technology, is in as private, non commercial, or company, 15Kw max output, offered globally for free, however, an voluntary size of donation, to wwwo2gruppen.se is gladly accepted to get a “free” license...

Anyone can now build his very own, generator.

License should be acquired for selling generators, the inventions name “WaveReaper” must be honored, as the inventors name Stefan Nystrom. Max 1 generator per kilometer shoreline. Account information, for donors/license takers, can be seen at start page wwwo2gruppen.se later Please, mail me a photo of your device, for educational purposes, and to help others get ideas, pictures will be promoted on this site!

Let everyone know, friend and foe, its time for things to change in the worlds energy sector.

Oil based economy, is gone, lets all accept it, and build a better world, feed the hungry, cure the sick, and of course, stop polluting the environment, with the oil based stone age technology.

Views: 94

Comment

You need to be a member of 12160 Social Network to add comments!

Join 12160 Social Network

Comment by cheeki kea on Saturday

I fear the 'idea' to exercise free wave energy has already been acquired and put into action to provide Non- Free- free energy to the grid to be $Paid$ for as usual. As occurred in Hawaii with the Azura Wave Energy Device as we find out. Weird name, sounds like something out of a steam punk magazine, except one for Hydraulics.  

Comment by Sabbatai Zevi on November 25, 2019 at 1:38am

Is this the same scientist that has been quoted saying he wants to step in front of a train rather than live in Sweden ? Hundreds of felonies deported from Australia.  

Comment by James Roberts on November 23, 2019 at 3:25pm

Thanks for posting, Phyllis. Another good one is the Minto Wheel - Wiki article .

I think the Pictet Experiment, described my Marc August Pictet in the early 1700s, may be an example that can be developed into a real source of free energy. Two parabolic (curved) mirrors are placed 10 to 12 feet from each other, aligned with each other, and a heat source (or source of cold) is placed in the focal point of one mirror. The bulb of a thermometer is placed in the focal point of the other. The temp goes up or down depending on the temp of what's at the first mirror. Conduction or convection cannot explain this. There must be energy coming from somewhere that mainstream science can not explain. I have ideas on how to make it output a great deal of energy, but I intend to profit from it, so, no explanations here. I am also not naive, as are most inventors, and I don't intend to get suicided.

Comment by Chris of the family Masters on November 23, 2019 at 2:42pm
Slaves cannot upset exploitation program. There are numerous examples of inventors killed.

"Destroying the New World Order"

THANK YOU FOR SUPPORTING THE SITE!

mobile page

12160.info/m

12160 Administrators

 

TOP CONTENT THIS WEEK

Latest Activity

Diana replied to Diana's discussion Man-Child Hunter Biden Skips First Court Hearing and His Lawyer ‘Abruptly Quits’
"Ruh-roh.  This is bad news for Hunter and Joe. EXCLUSIVE: Hunter Biden will now have to hand…"
15 minutes ago
Diana commented on Diana's photo
Thumbnail

Joe Might Go Corn Pop

"Washington Examiner ✔@dcexaminer "Stick it up your ass, fella."Voter that challenged…"
24 minutes ago
Mr. Sizzle commented on Diana's photo
Thumbnail

Turn Them Into The "International Children Of The Future."

"I’m not saying Russians, I’m saying (((…"
52 minutes ago
Mr. Sizzle favorited Diana's photo
59 minutes ago
Mr. Sizzle favorited Diana's photo
59 minutes ago
Mr. Sizzle favorited Diana's photo
1 hour ago
Burbia commented on DTOM's group Beyond High Tech
2 hours ago
Diana posted videos
2 hours ago
Diana posted photos
3 hours ago
cheeki kea favorited Diana's photo
3 hours ago
cheeki kea commented on Diana's blog post Jeffrey Epstein’s Private Banker Found Swinging From A Rope
" They must be getting tied up with all the overkill drama, and now need a quick simple ending."
3 hours ago
Doc Vega commented on Doc Vega's blog post Former Planned Parenthood Whistle Blower Dies
"James, you know, it seems the atrocities of Planned Parenthood far outweigh any abortion clinic…"
3 hours ago
cheeki kea commented on Diana's blog post Jeffrey Epstein’s Private Banker Found Swinging From A Rope
3 hours ago
Doc Vega commented on Diana's blog post Jeffrey Epstein’s Private Banker Found Swinging From A Rope
"Amazing! first you hang yourself then while dangling with a constricted windpipe you manage to…"
3 hours ago
JoeG favorited cheeki kea's photo
3 hours ago
cheeki kea commented on cheeki kea's blog post Taxpayers union Reveals Chinese propaganda funded by NZ film subsidies
"funny, beheading hasn't happened for some time, but if they come here they pay low wages, the…"
3 hours ago
Chris of the family Masters favorited Doc Vega's blog post Odd and Bizarre News from the Past
4 hours ago
Mr. Sizzle's 2 photos were featured
4 hours ago
cheeki kea's photo was featured
4 hours ago
Diana favorited cheeki kea's photo
4 hours ago

© 2019   Created by truth.   Powered by

Badges  |  Report an Issue  |  Terms of Service

content and site copyright 12160.info 2007-2019 - all rights reserved. unless otherwise noted