Cheese Wax Will Save Us All

By Kellene

visit us at:   www.preparednesspro.com.

See website link for full article:

A couple of tips you should know though.

1. Don’t use paraffin wax.  It tends to crack.  Cheese wax warms slower and heats to a higher temperature and thus plies better to your cheese shapes and sizes.  Cheese wax is also less crumbly and you can use less of it than paraffin. Remember, it’s reusable too!
2. I have yet to find a hard cheese that I can’t wax.  So long as it’s hard enough to be in a solid block, you can wax it.
3. You don’t need cheesecloth, but if you desire to use it prior to your wax layers, it may be helpful getting the wax off.  I haven’t had any problems without it though.
4. It’s best to melt the cheese wax in a double boiler as opposed to direct heat. Any pan you use to melt your cheesewax in will be your designated cheese wax pan. They are impossible to get clean afterwards. So be forewarned.
5. The less you handle the cheese with your hands the better. Use food handling gloves.
6. Dip the cheese in for about 5 seconds, then bring it out and HOLD it there for about 90 seconds. Do 3 layers of dipping and then one layer of brushing.  (Using the natural boar’s hair brush)  The reason why you want to use this kind of brush specifically is because other brushes will apply the cheese wax too thick, or with crevices, etc.  This kind of brush is perfect for cheese waxing.
7. You don’t need to use food-grade labels for your cheese, however, it’s smart to use a label on the outside of your cheese just prior to the last wax layer.  That way you don’t have to worry about it falling off.  Be sure to label not only the kind of cheese it is, but when it was waxed as well.
8. Don’t store your waxed cheese in additional containers.  Just stack them on top of like cheeses and let them breathe.  I like to hang them from the ceiling in a “fishing net” kind of contraption.
9. Be sure to check for pockets or crevices that didn’t get sealed.  Four total thin layers of wax is a good practice.  There’s no need to do more coats than that.
10. The cheese surface should be clean and dry prior to waxing.
11. If your 2^nd and 3^rd coats are applied while the prior coat is still just a bit warm you will get a better adhesion.
12. Cheese wax can be re-used several times.  You can simply wash it in warm water, let it dry and then re-melt it.  So when you remove cheese wax from your cheeses, you can simply reheat and reapply the wax.  Simply heat the cheese wax to about 200 degrees F.  This will also ensure that you’re not transferring any bacteria or unnecessary moisture to your new cheese–even when you’re putting it on your cheese which is cooler.
13. You do not need to filter the cheese wax after you melt it.  So don’t worry about that step.
14. Your first coat will have some unevenness to it.  Don’t worry.  The 2^nd and 3^rd coat will even it out just fine.
15. Cheese will respond to gravity. So using cheesewax vs. paraffin is important as it’s more pliable. I periodically turn my cheese in view of the gravitational pull.