HAARP Data Says Japan Quake was Induced

Monday, March 21, 2011HAARP Data Says Japan Quake was Induced
ExoHuman

THE UNITED STATES Air Force and Navy has provided a visual insight into what caused the 9.0 magnitude off of Japan on March 11, 2011 at 05:46:23 UTC. The image above was downloaded from the High Frequency Active Auroral Research Program (HAARP*) website. It is a time-frequency spectrogram, which shows the frequency content of signals recorded by the HAARP Induction Magnetometer. This instrument, provided by the University of Tokyo, measures temporal variations in the geomagnetic field (Earth’s magnetosphere) in the ULF (ultra-low frequency) range of 0-5 Hz. Notions have been added to the image to show you what was happening the day the Japan earthquake and tsunami struck.

By looking at the accompanying HAARP spectrum chart above you can see when the 9.0 magnitude earthquake struck – red line drawn vertically – and what was happening before and after the earthquake. What you can also see is a constant ULF frequency of 2.5 Hz being recorded by the magnetometer. The ULF 2.5 Hz frequency is evidence of an induced earthquake. The chart recorded this constant before, during and after the 9.0 magnitude earthquake struck.

On March 11, 2011 the 2.5 Hz ULF frequency was being emitted and recorded from 0:00 hours to about 10:00 hours – or for 10 hours. We know for a fact that the Japan earthquake lasted only a few minutes so why was the earthquake signature frequency (2.5 Hz) being recorded for 10 hours on the morning of March 11, 2011? Because a HAARP phased array antenna system was broadcasting (transmitting) the 2.5Hz ULF frequency and it triggered the Japan earthquake and ensuing tsunami

read more http://www.activistpost.com/2011/03/haarp-data-says-japan-quake-was...

Favorite

1 member favorited this

Comment

You need to be a member of 12160 Social Network to add comments!

Join 12160 Social Network

Comment by Andy Anduer on March 23, 2011 at 3:44am: I'll give it a whirl and see what happens!

Comment by WTRH-AM-AE on March 22, 2011 at 3:00pm: 1. Set up a computer with spectrogram analysis software then connect it to a sensor that receivers 0.1 Hz to 10 Hz, then you can detect the signature. 2. The line of 2.5 Hz is the modulated heat signal that occured for 10 hours then after the Earthquake occured the modulated heat signal signed off at 8:30 UTC. 3. It's like you turn on something and leave it on like a stove trying to boil a pot of water, leave for 10 minutes (10 hours in this spectrogram) and at 05:46 UTC it started to really boiled and caught on fire (caused the Earthquake) and then they turned off the stove (heat modulator).

Comment by Andy Anduer on March 21, 2011 at 10:30pm: We need some well-educated people to nail it down so it can't be denied.

Comment by Marklar on March 21, 2011 at 8:28pm: A possibility perhaps except:

1. You absolutely CANNOT identify that wave as being 2.5Hz from the chart given. The time scale is far too broad for that.

2. Correlation doesn't necessarily indicate causation