How to block/kill RFID chips
In this Instructable I will describe different ways to block or kill RFID tags. RFID stands for Radio Frequency Identification. If you do not know about this technology yet, you should definitely start familiarizing yourself with it, because the number of different devices that utilize these types of tags is growing exponentially.
RFID chips are very similar to barcodes in the sense that a certain amount of data is contained within them, and then transmitted to a reading device which then processes and utilizes the information. The major difference is that barcodes have to be physically visible to the reading device, which is usually only able to scan them at a distance of a 12 inches or less. RFID tags, on the other hand, do not have to be visible to the reading device. They can be scanned through clothes, wallets, and even cars. The distance from which they can be read is also much greater than that of a barcode. At DEFCON an RFID tag was scanned at a distance of 69 feet, and that was back in 2005, the possible reading distance now is probably much greater than that.
There are a few different categories of RFID tags, but the most common ones, and the ones we will be dealing with in this instructable, are the "passive" type. Passive RFID chips contain no internal power supply. They contain an antenna which is able to have a current induced in it when within range of the RFID reader. The tag then uses that electricity to power the internal chip, which bounces its data back out through the antenna, where it will be picked up by the reader.
For more information on RFID tags check out the wikipedia entry.
Where can RFID chips be found
As RFID chips become cheaper, the number of devices that include them grows.
Currently there are RFID tags in:
- US passports: The RFID tag contains all the information that is written in the passport, along with a digital picture
- Transportation payments: Things like New York's EZ Pass, Florida's Sun Pass, and California's Fast Trak are all RFID based toll payment systems.
- Access control: Many buildings and schools require RFID tagged cards to be used for entry.
- Credit cards: Chase, and a few other banks, now issue credit cards embedded with RFID chips, called "blink". They are able to convince people it is an added convenience, but in reality it is a huge security risk. There are many other devices which contain RFID tags; however, the ones listed are the most common and offer the greatest security risk.
Currently there are RFID tags in:
- US passports: The RFID tag contains all the information that is written in the passport, along with a digital picture
- Transportation payments: Things like New York's EZ Pass, Florida's Sun Pass, and California's Fast Trak are all RFID based toll payment systems.
- Access control: Many buildings and schools require RFID tagged cards to be used for entry.
- Credit cards: Chase, and a few other banks, now issue credit cards embedded with RFID chips, called "blink". They are able to convince people it is an added convenience, but in reality it is a huge security risk. There are many other devices which contain RFID tags; however, the ones listed are the most common and offer the greatest security risk.
Luckily RFID tag signals can easily be blocked. This means that you will have the option to use the tag whenever you want, and prevent others from being able to read it.
The signal sent out by a RFID tag is easily blocked by metal. This means that placing the RFID tag inside of a Faraday cage will prevent the information from being read.
.
-The easiest way to kill an RFID, and be sure that it is dead, is to throw it in the microwave for 5 seconds. Doing this will literally melt the chip and antenna making it impossible for the chip to ever be read again. Unfortunately this method has a certain fire risk associated with it. Killing an RFID chip this way will also leave visible evidence that it has been tampered with, making it an unsuitable method for killing the RFID tag in passports. Doing this to a credit card will probably also screw with the magnetic strip on the back making it un-swipeable.
-The second, slightly more convert and less damaging, way to kill an RFID tag is by piercing the chip with a knife or other sharp object. This can only be done if you know exactly where the chip is located within the tag. This method also leaves visible evidence of intentional damage done to the chip, so it is unsuitable for passports.
-The third method is cutting the antenna very close to the chip. By doing this the chip will have no way of receiving electricity, or transmitting its signal back to the reader. This technique also leaves minimal signs of damage, so it would probably not be a good idea to use this on a passport.
-The last (and most covert) method for destroying a RFID tag is to hit it with a hammer. Just pick up any ordinary hammer and give the chip a few swift hard whacks. This will destroy the chip, and leave no evidence that the tag has been tampered with. This method is suitable for destroying the tags in passports, because there will be no proof that you intentionally destroyed the chip.
The signal sent out by a RFID tag is easily blocked by metal. This means that placing the RFID tag inside of a Faraday cage will prevent the information from being read.
.
-The easiest way to kill an RFID, and be sure that it is dead, is to throw it in the microwave for 5 seconds. Doing this will literally melt the chip and antenna making it impossible for the chip to ever be read again. Unfortunately this method has a certain fire risk associated with it. Killing an RFID chip this way will also leave visible evidence that it has been tampered with, making it an unsuitable method for killing the RFID tag in passports. Doing this to a credit card will probably also screw with the magnetic strip on the back making it un-swipeable.
-The second, slightly more convert and less damaging, way to kill an RFID tag is by piercing the chip with a knife or other sharp object. This can only be done if you know exactly where the chip is located within the tag. This method also leaves visible evidence of intentional damage done to the chip, so it is unsuitable for passports.
-The third method is cutting the antenna very close to the chip. By doing this the chip will have no way of receiving electricity, or transmitting its signal back to the reader. This technique also leaves minimal signs of damage, so it would probably not be a good idea to use this on a passport.
-The last (and most covert) method for destroying a RFID tag is to hit it with a hammer. Just pick up any ordinary hammer and give the chip a few swift hard whacks. This will destroy the chip, and leave no evidence that the tag has been tampered with. This method is suitable for destroying the tags in passports, because there will be no proof that you intentionally destroyed the chip.
"Destroying the New World Order"
THANK YOU FOR SUPPORTING THE SITE!
Latest Activity
- Top News
- Everything
THE GREAT FLOOD Official Trailer (2026) Netflix | Global Disaster Movies 4K
🌊 A world pushed past the breaking point.In THE GREAT FLOOD (2026), rising oceans, collapsing cities, and unstoppable storms trigger a global disaster unlik...
Mothman Prophecies
When suddenly the universe looked downIt seemed everything came unwoundI wondered if my sanity was…See More
"Joined Facebook after a 5 year absence. One absolutely undeniable picture that Hunter was in!!!!"
The 100 Series Designated for SAC and a Possible WWIII
The “100 Series” as these fighter aircraft were labeled were a succession of Mach II capable…See More
Human Be-In - Full Program - 1/14/1967 - Polo Fields, Golden Gate Park (Official)
Human Be-In - Full ProgramRecorded Live: 1/14/1967 - Polo Fields, Golden Gate Park - San Francisco, CAMore Human Be-In at Music Vault: http://www.musicvault....
"So sad to see a nice place be ruined by its inhabitants.... It's that shitholeness spreading…"
"Jesus Christ this is more diabolical than just about anything I've studied even though I knew…"
"Less Prone Nothing wrong with the planet. It's the inhabitants who are the problem."
"That assignment on the blue planet intrigued me a lot. And here we are now! I cannot say it's…"
Sebastion Piñera and 5G
Sebastion Piñera “The start of the bidding process for the 5G network. Let’s listen to the threats…See More
© 2025 Created by truth.
Powered by
